pcm module

Since Origin / Contributor Maintainer Source
2016-06-05 Arnim Läuger Arnim Läuger pcm.c

Play sounds through various back-ends.

Sigma-Delta hardware

The ESP contains a sigma-delta generator that can be used to synthesize audio with the help of an external low-pass filter. All regular GPIOs (except GPIO0) are able to output the digital waveform, though there is only one single generator.

The external filter circuit is shown in the following schematic. Note that the voltage divider resistors limit the output voltage to 1 VPP. This should match most amplifier boards, but cross-checking against your specific configuration is required.

low-pass filter

Important

This driver shares hardware resources with other modules. Thus you can't operate it in parallel to the sigma delta, perf, or pwm modules. They require the sigma-delta generator and the hw_timer, respectively.

Audio format

Audio is expected as a mono raw unsigned 8 bit stream at sample rates between 1 k and 16 k samples per second. Regular WAV files can be converted with OSS tools like Audacity or SoX. Adjust the volume before the conversion.

sox jump.wav -r 8000 -b 8 -c 1 jump_8k.u8

Also see play_file.lua in the examples folder.

pcm.new()

Initializes the audio driver.

Sigma-Delta driver

Syntax

pcm.new(pcm.SD, pin)

Parameters

pcm.SD use sigma-delta hardware - pin 1~10, IO index

Returns

Audio driver object.

Audio driver sub-module

Each audio driver exhibits the same control methods for playing sounds.

pcm.drv:close()

Stops playback and releases the audio hardware.

Syntax

drv:close()

Parameters

none

Returns

nil

pcm.drv:on()

Register callback functions for events.

Syntax

drv:on(event[, cb_fn[, freq]])

Parameters

  • event identifier, one of:
    • data callback function is supposed to return a string containing the next chunk of data.
    • drained playback was stopped due to lack of data. The last 2 invocations of the data callback didn't provide new chunks in time (intentionally or unintentionally) and the internal buffers were fully consumed.
    • paused playback was paused by pcm.drv:pause().
    • stopped playback was stopped by pcm.drv:stop().
    • vu new peak data, cb_fn is triggered freq times per second (1 to 200 Hz).
  • cb_fn callback function for the specified event. Unregisters previous function if omitted. First parameter is drv, followed by peak data for vu callback.

Returns

nil

pcm.drv:play()

Starts playback.

Syntax

drv:play(rate)

Parameters

rate sample rate. Supported are pcm.RATE_1K, pcm.RATE_2K, pcm.RATE_4K, pcm.RATE_5K, pcm.RATE_8K, pcm.RATE_10K, pcm.RATE_12K, pcm.RATE_16K and defaults to RATE_8K if omitted.

Returns

nil

pcm.drv:pause()

Pauses playback. A call to drv:play() will resume from the last position.

Syntax

drv:pause()

Parameters

none

Returns

nil

pcm.drv:stop()

Stops playback and releases buffered chunks.

Syntax

drv:stop()

Parameters

none

Returns

nil